In early 2011, I overheard someone say “you can’t do that in Revit”. It turned out that the conversation was referring to families and that they could not be scaled.

I have to admit that I had never given scaling of families much thought before because I never felt there was a need for me to scale a family.

I, however, could see the need to use a family that could be scaled, and so I decided to investigate further. Since that time I have determined that every family I tested could be scaled. This, of course is only true if the family is built with this intention in mind.

The steps to scale a family depends on a variety of factors that are unique from family to family. It is also possible to built scale into a family “after the fact” as shown in the image below. I took the Revit Cow and with no time at all made it “scalable”.

I do not intend to spell out how to make a family scalable in this blog post. I just wanted to point out the fact that it could be done in Revit on every family I tested.

Scaling the Revit Cow(s)

2 thoughts on “Scaling Revit Families

  • Phyllis Robbins

    May I take your comment "any family" at face value including hosted families, annotation families and families of all flavors? Or is the technique restricted to adaptive components? I see many, many applications in our architectural practice but before I investigate further and find the solution, an answer to my question would be the hint I need to get started. Thank you in advance.

  • Unknown

    Marcello-
    I didn't see your reply to your previous post (http://therevitcomplex.blogspot.com/2011/09/revit-cow.html) until recent. Here is my contact info:
    bderrick@ffkr.com
    Thanks!
    -Brian

Comments are closed.